Error / Status | CP Series LED Indicator Definitions
This article provides a comprehensive guide to understanding the error and status definitions for CP Series LED Indicators.
Affected Products
| Hardware Model/Series | CP Series Powered Loudspeakers |
| Software |
Message
The CP Series Powered Loudspeaker have several LED indicators to show statuses for the unit.
Definition
The table below defines the statuses for each indicator on the CP Series powered loudspeakers.
|
LED Indicator (see image above) |
Status |
|---|---|
| 1 - Input A Sig LED | When illuminated (green), it indicates a signal is present. If this LED is not illuminated, the input signal is missing or too low to detect. |
| 3 - Input B Sig LED | When illuminated (green), it indicates a signal is present. If this LED is not illuminated, the input signal is missing or too low to detect. |
| 7 - Limiter LED | Illuminates (red) when the built-in limiter is activated to avoid damage to the amplifier or loudspeaker. If the signal level at any frequency is too high, or the amplifier is too hot, the limiter is activated and the LED is illuminated. |
| 8 - Power LED | Illuminates (green) when power is applied to the unit and the ON/OFF switch is in the ON position. |
| 9 - Mic Boost LED |
When illuminated (yellow) it indicates the input is configured to provide a +25 dB boost for microphones requiring a higher input gain. When not illuminated, it indicates the input is configured for a line-level input including microphones that provide a standard line-level output. NoteThe MIC BOOST setting should only be used if a microphone is connected directly to the MIC/LINE input. |